This Disc Brake Conversion kit uses Chevy 1/2 ton brakes with the sliding calipers, and the 6 bolt spindles and outer C's.
When putting this kit on a Ford axle you will need to replace your five bolt outer C's with six bolt outer C's from a Chevy of Jeep axle.
Minimum 15" steel wheel recommended.
Some 15" aluminum wheels may require light grinding of the calipers and/or wheels.
(2) HUBS (5 x 5 1/2")
SET OF FRONT BRAKE PADS
(1) RH Caliper
(1) LH Caliper
Mounting hardware/hard line not included Master cylinder not included.
Ford stub axles may be re-used but it is suggested to use the GM 9.94" W38815 to retain the use of the outer locking hub snap ring.
Add optional brake backing plate and 9.94" stub axles to the kit during check out.